Skip to main content
FREE Delivery!|(316) 799-3265
Bulk Gravel Delivery to Dexter, KS

Bulk Gravel Delivery to Dexter, KS

If you are planning gravel and aggregate delivery in Dexter, KS, the job usually starts with a base. A patio needs a bed that will not shift, a shop pad needs a firm footing, and a drainage run needs clean stone that lets water move.

Kansas Rock Supply delivers AB-3 and the supporting materials for work like that.

This is Flint Hills ground, where soil is thin and cherty over limestone. That shapes what you put down before anything else goes on top.

Ground and Conditions in Dexter

Across the Flint Hills, soil runs thin and cherty over flat-lying limestone and shale. On the hilltops there is often a cap of cherty gravel, and rock can sit only inches below the surface.

When a base over ground like that is too shallow, it shows up fast. The surface ruts, the edges break away, and pavers or slabs rock underfoot because there was never enough material under them to hold.

The fix is a proper base course, and AB-3 is the material Kansas uses for it. AB-3 is the local name for dense-graded crushed limestone base: crushed rock and fines together, graded roughly 1 1/2 inch down.

Moisture-conditioned and rolled, it locks up tight.

Water is the other half of the story. Runoff leaves limestone ledges instead of soaking in, so it arrives fast and concentrated at the foot of a slope.

Clay in the valley bottoms holds it.

That fast water cuts ditches and drive edges. A long open working season helps here, though wet spring weeks slow things down.

Thin soil over rock also dries quickly once rain stops, so the ground comes back to workable soon after.

Winters bring repeated freezing and thawing. Shallow soil over rock freezes through quickly and thaws from the top, which is hard on any unbound surface.

Materials for Dexter Projects

Bedding under pavers and flatwork is where a project earns its finish. Get the bed right and the surface stays flat and tight.

Get it wrong and every slab rocks.

Screenings are the crusher fines left after limestone is screened, and they are the standard bedding under pavers and flagstone. They also level under flatwork and fill paver joints.

Washed Sand, also called concrete sand or river sand, beds and levels under slabs and pavers. It is also the sand for concrete work.

Mason Sand goes into brick and block work, paver joints, sandboxes and volleyball courts.

Under all of that, AB-3 is the compacted base for drives, parking pads, and shed and shop floors.

For drainage, 1 Inch Clean is clean washed limestone, sold by inch size here and called clean rock. It goes in French drains, foundation drains, pipe bedding and construction entrances.

Delivery to Dexter and the Surrounding Area

Quantities are ordered by the ton or by the yard, whichever you prefer to work in. Each product page has a calculator to help you size the load before you order.

You order online, pick a delivery date at checkout, and a dump truck tips the load on site in one pile. Bulk delivery covers Dexter and the rest of Cowley County, including Arkansas City, Winfield, Udall, Burden and Atlanta.

Order Gravel and Aggregate for Your Dexter Project

Start with the calculator on the product page and settle your quantity in tons or yards. Then place your order online and choose a delivery date for your Dexter or Cowley County site.

Kansas Rock Supply will have the material on the truck and tipped where you need it.

Frequently Asked Questions

Common questions about gravel and aggregate delivery in Dexter, KS

What gravel is best for a driveway in Dexter?

AB-3 is the base most Dexter drives are built on. It is dense-graded crushed limestone, rock and fines together, graded roughly 1 1/2 inch down, and it locks up tight when moisture-conditioned and rolled. Top it with Driveway Gravel, or with 1 inch minus for patching soft spots and building up shoulders.

How much material will my project need?

Order by the ton or by the yard, and use the calculator on any product page to size the load from your own project numbers. That keeps the quantity in your hands before checkout. For a base course, AB-3 is the material to figure.

How is the material measured?

You can order by the ton or by the cubic yard, whichever suits how you plan the job. If you tell us the area you are covering and the depth you want, we will work the quantity out with you rather than leaving you to guess.

Nearby