Gravel, Stone and Soil for Marion County, KS
Kansas Rock Supply sells gravel, stone and aggregate delivery in Marion County, KS. Start with the calculator on any product page to size your load, then pick the material that fits the job.
AB-3 is the base most Kansas ground calls for, and it is the name a contractor here uses when ordering base. It is crushed limestone and fines graded roughly 1 1/2 inch down.
Delivery across Marion County
Order online and choose a quantity by the ton or by the yard. Pick your delivery date at checkout, and a dump truck tips the load on site.
Bulk delivery reaches Hillsboro, Marion, Peabody, Florence, Burns, Lehigh, Lincolnville, Tampa, Ramona, Lost Springs and Durham. Each product page has a calculator if you need help sizing the load.
The truck tips the material in one pile. Think about where that pile should sit before the truck arrives, because the driver does not spread or spot the load.
Materials delivered in Marion County
Order by project. A driveway wants dense-graded base under a topping course, a patio wants bedding and joint material, and a drain wants clean washed stone.
Base material in Kansas is specified that way, and the requirements for aggregates for base construction sit in Section 1104, inside Division 1100 of the Kansas Standard Specifications for State Road and Bridge Construction.
City and county work references the same class, so AB-3 is the term to use when you order base. Say road base and the yard will still know what you mean, but AB-3 is the local name.
For a driveway, start with AB-3 and top it with driveway gravel. For a walkway, walkway gravel gives a finer surface underfoot.
Ground conditions across Marion County
Marion County sits in the Flint Hills. The soil across this part of the state is thin cherty clay over flat-lying Permian limestone and shale, with cherty gravel on the hilltops.
Rock often sits only inches below the surface. That changes what a base course has to do, because the ground under it will not absorb water the way deeper soil would.
Water runs off the limestone benches instead of soaking in. It arrives fast and concentrated at the foot of a slope, while clay in the valley bottoms holds it.
Fast runoff off limestone ledges cuts ditches and drive edges. That is why ditch lining and slope protection matter here, and why RipRap and clean stone are common answers at culvert outlets and bank edges.
Across the Flint Hills, thin soil over rock dries out quickly once the rain stops, so ground is usually workable again soon after a wet spell. The working season runs long, broken by wet spring weeks.
Winters bring repeated freezing and thawing. Shallow soil over rock freezes through quickly and thaws from the top, which is hard on an unbound surface.
Frost depth is set by the local building official, not by the state.
Choosing the right material
Marion County's ground is Flint Hills ground. Harvey County and McPherson County sit on a different base: sand, gravel and silt laid down by the Arkansas River, with stabilized dune sand and a sandy loam over the top.
That sandy ground drains on its own, so bedding and drainage choices there can be lighter. On the thin clay and rock here, water needs a place to go, which points to clean washed stone for drains and a dense-graded base under drives and pads.
Dickinson County ground is silty and clayey over Cretaceous rock, with Dakota sandstone, Greenhorn limestone and Niobrara chalk, plus loess on many uplands. It is a different rock and a different soil from the Permian limestone and cherty clay here.
For a patio, bed pavers on Screenings and fill the joints with the same material. For drainage, use 1 Inch Clean or Drain Rock so water moves instead of sitting.
Order AB-3 and washed stone for Marion County
AB-3 is the base material this county's ground calls for, and clean washed stone is what keeps water moving where the clay holds it. Kansas Rock Supply delivers gravel, stone and soil across Marion County.
Order online, size the load with the calculator, and pick your delivery date at checkout.